Edelbrock 2.5" header flanges (pair)

Do you want to buy the same header flanges we use to build our orders? Here are the flanges that are available for purchase. 

Step 1 - Select the size primary  you would like (1 5/8", 1 3/4" and 1 7/8")

Step 2 - Select YES if you would like primary piping stubs welded on the flange (8x and 1.5" long), Select NO if you just want the flange normal.

Flanges - 3/8" thick with round ports (if stub option is selected and you want to gasket match you can since we weld from the outer side and not the inside of the primary pipe to header flange)

Bolt Pattern - 2.5" Horizontal (measure from center of bolt hole across the exhaust port to the other center of bolt hole. That should be 2.5")

 *** Note *** Picture shown is an example but not the actual design of this flange.