| Vehicle |
- 1979-1993 mustang or fox body vehicle |
| Engine |
- 302 based (8.2 deck) or 351 (9.5) is extra $$$ |
| Turbo Placement |
- front to back on the passenger side |
| Accessories kept |
- alternator, power steering, & air conditioning with mods (unless 351) |
| Other |
- must remove the smog pump, smog plumbing,
& trim drivers side sway bar bracket for header clearance |
The stage 2 "original design" single turbo headers and crossover kit is great for a stock or stockish motor combo. But it is still capable of pushing 300 to 700 horsepower depending on your engine mods, turbo, & boost level You can keep the factory p/s, a/c, and alternator in the factory locations, making it a direct bolt in kit with just one tiny area to clearance (listed above in "other"). This kit includes the passenger header, drivers header, crossover pipe, & v band clamps. For a downpipe or any other optional upgrades look below and make your selections.
* Will fit up to a 76mm turbo. Will NOT fit a borg warner s400 t4 series turbo or 88mm t4 turbo with out mods!
Instructions
Specs:
- 95% TIG welded
-1 5/8" primary headers
-1 piece header flange
-2 1/2" crossover ( w/ slip joint, and v band flanges)
-t4 turbo inlet flange
-headers & crossover are made from 16g mild steel
-flanges are 3/8" mild steel
Limited 4 year warranty
This product was added to our catalog on Wednesday 27 January, 2010.
