Vehicle |
1979-1993 mustang or fox body vehicle |
Engine |
302 based (8.2 deck) or 351 (9.5) is extra $$$ |
Turbo Placement |
Left to Right (inlet will face towards the stock air box
area) |
Accessories kept |
alternator, p/s, & a/c |
Other |
Must trim LH sway bar bracket, and 3 spots on passenger side,
eliminate the smog pump & plumbing |
This Pony Down (b series) Stage 2 single turbo kit is a
passenger side turbo mounted kit for ease of installation, clean looks, and it
allows you to keep the factory a/c and p/s. But the smog pump and plumbing will have to be removed. Plus with the design of our cold side we can
build the kits for fuel injection using a mass air meter (blow through), speed
density, or carbed. The horsepower rating of this kit is from as low
of 300hp to 750hp depending on your engine combo and the amount of boost you
run. All the specs of this kit is exactly the same as our original stage 2 kit.
What we did is just change the location of the way the turbo sits. By doing that
it allowed us to run the downpipe under the passenger side header allowing you
not to have to take apart the downpipe for plug changes. The only draw back to
that was you have to trim a couple of areas on the passenger side for one pipe,
one drain hose, and the air filter. This is a complete kit alls you have to do
is add a mass air meter and fuel upgrades (injectors and fuel pump) and your
done. Looking below on our options everything is setup for a standard stage 2
kit. But there are options for upgrades and even a option to have the kit built
for a 351.
*fyi* Our y-pipe ($249.99) takes place of your h or x pipe and allows your cat
back exhaust to directly bolt up so there is no need to find a exhaust shop to
finish off your exhaust.
Specs:
Turbo |
Turbonectics 72mm, Upgrades available up to 76mm |
Headers |
1 5/8" primary headers, with 1/2" flanges |
Crossover |
2 1/2" with v bands, slip joint |
Down pipe |
2 piece 3" downpipe, & 2x 02 sensor bungs |
Wastegate |
(standard) Tial 38mm (optional) Tial 44mm |
Cold Side Piping |
3" Aluminum piping from the turbo to the throttle body with bead rolled ends |
Silicone |
all silicone couplers and hose clamps included |
Blow off Valve |
Tial 50mm |
Intercooler |
Pony Down Stage 2 - air to air (3" in / 3" out) with
mounting brackets and hardware |
Oil Feed/Drain |
aeroquip -4 steel braided feed line with aeroquip fittings,
aeroquip drain hose with turbo drain flange, barbed fittings, & hose clamps
|
Filter |
4" k&n |
Pipe Coating |
(standard) Silver or Flat Black (optional) Ceramic Silver or
Ceramic Black |
Limited 4 year warranty