Vehicle | - 1979-2004 mustang with a push rod motor |
Engine |
- 302 based (8.2 deck) or $ 351 based (9.5 deck) $ |
Turbo Placement | - Custom |
Accessories kept | - Custom |
Other |
- 9.2 motors might have to run a shorty spark plug and 90
degree spark plug boot on the passenger side header |
These "R" (race) headers are a great starting point for our racers and
fabricators out there. They are a set of 1 3/4 primary headers with the collectors on a 45* angle and a v-band welded on the end. What we do is get is the hard part done.
It will allow you to mount the turbo where you want it and just do the piping from the headers to the turbo. These are great for t6,
t4 builds or any build that needs for a custom turbo location on your car. With
the sizing of these primaries you could make them into a forward exiting header.
Specs:
1/2" header flanges
1
3/4" primaries (16g mild steel)
1 3/4" into 3" or 2 1/2" collector (16g mild steel)
3"
or 2 1/2" v band ring welded on the collector
*FYI* We can make these headers for the following bolt patterns - standard sbf (2"), trick flow r (2.75"), trick flow high port, and fel pro 1487 (3")
This product was added to our catalog on Tuesday 26 January, 2010.